Tascam CD-GT1, Руководство пользователя

Страница: 10 / 68

10
— TASCAM CD-GT1
English
English
Using the CD player
 e s  player works  e s  player works
in much the same way as other  in much the same way as other 
players with a few minor diff erences players with a few minor diff erences
and special features as explained on and special features as explained on
this page
oad s label side up shiny side
down in the  pen and
close the player door by hand
Playback
ress the playpause key 
y

J
 key to
start playback and to pause playback
ress the stop key 
H
 to stop play
back
hen you use the player with batter
ies starting and stopping playback take
longer than under  power this saves
battery power
Display
se the DISPLAY/ESC key to change
the display between track elapsed
time track remaining time and total
remaining time you cannot do this in
menu mode
Skipping between tracks
se the two skipsearch keys marked
as
m
/
.
and
/
/
,
 to move
back and forward a track at a time by
pressing and releasing the appropri
ate key
Searching within tracks
se the skipsearch keys to search
within the disc by pressing and holding
the appropriate key
The CUE key
 e CUE key is a special feature of the
 hen you press this key
the playback position returns to the last
point where playback started
hat happens next depends on the
CUE
menu item setting in the
MENU
menu
f this is set to
CUE
 playback is paused
at the cue point but if it is set to
FLS

playback restarts from the cue point if
CUE is pressed from play or pause
TIP
With a footswitch connected, you can use
this instead of the
CUE
key for hands-free
operation (set the FOOT menu item to CUE ). CUE CUE
Looping (track)
sing the
PLAY
menu item set
SGL
sin
gle play ress the LOOP key so that
you see
LOOP 1
on the display bottom
left  e current track will repeat
Looping (disc)
sing the
PLAY
menu item set
ALL
play
all the disc ress the LOOP key so
that you see
LOOP
alone on the display
bottom left  e whole disc will
repeat
Looping (I/O points)
se the I/O key to set the start in
point of the loop then use the key to
set the out point  e section between
the points will repeat seamlessly
ressing the
I/O key again clears the
loop points and cancels loop mode
ith these points set 
I-O
shown on the
display you can restart the  loop
mode if it has been canceled using the
LOOP key
Canceling looping
ress the LOOP key so that
LOOP
does
not show on the display bottom left