15
ASSEMBLY
5. Replace and tighten the check plug.
6. Replace and tighten the 1/2” vented pipe plug and
clean away any excess oil.
7. Using a 7/8” wrench, remove the pipe plug
located at the top of the side gearbox and using a
9/16” wrench, remove the check plug located on
the side of the side gearbox.
8. Fill the side gearbox using specified gear oil until
the oil begins to overflow from the check plug
hole. (Holds approx. 2-1/2 quarts.)
9. Replace and tighten the vented pipe plug and the
check plug. Clean away any excess oil.
10. Grease the grease fitting on the outboard hub.
BEFORE PUTTING YOUR ROTARY TILLER INTO
SERVICE
NOTE:
Fill the gearboxes using 85W90 gear oil. For
all grease fittings use TYPE/Grade II tube grease.
1. Please ensure that your Rotary Tiller is secure
and level.
2. Using a 7/8” wrench, remove the vented pipe plug
located on front of the gearbox, above the PTO
shaft.
3. Using a 9/16” wrench remove the check
plug, located on the back of the gearbox.
4. Fill the gearbox, the front, using specified gear oil,
until oil begins to overflow from the check plug
hole in the rear. (Holds approx. 1-1/2 quarts.)
IMPORTANT: DO NOT overfill gearbox. This
could cause damage to oil seals and can
cause permanent damage to the gearbox.
This issue will not be covered under warranty.
IMPORTANT:
This tiller was shipped without
oil in the gearboxes and without grease in the
the grease fittings.
UNIT MUST BE SERVICED BEFORE USE.
IMPORTANT: DO NOT overfill gearbox. This
could cause damage to oil seals and can
cause permanent damage to the gearbox.
This issue will not be covered under
warranty.
