Tar River SRB-870, Инструкция по эксплуатации

Страница: 16 / 44

16
Attaching the PTO shaft
Danger
•
Never use PTO shaft with damaged safety cover or without safety cover.
•
Inspect it if damage is found out on PTO shaft.
•
Stop the tractor engine and disengage PTO clutch when PTO shaft is attached.
•
Fix chains of safety cover to the tractor and stationery part of the machine not to rotate safety
cover.
Caution
•
If overlap length between inner and outer tube of PTO shaft is less than 100 mm in extended
position, it will be a cause of PTO shaft breakage.
If the space between inner and outer tube is less than 25 mm in retracted position, it will be a
cause of damage.
By pushing to each other when the machine is lifted.
Shortening a PTO Driveline
1. With the implement attached to the tractor’s three point hitch, and the PTO driveline not installed,
separate the PTO driveline. Attach the implement end to the implement and the other end to the
tractor PTO input shaft.
2. Raise the implement by using the tractor’s hydraulic 3 - point hitch to it’s maximu m lift height.
3. Hold the half shafts next to each other and mark them so each end is approximately ½” from hitting
the end of the telescopic profiles.
4. Shorten the inner and out guard tubes equally.
5. Shorten the inner and outer profiles by the same length as the guard tubes. Using a rattail file, round
off all sharp edges and burrs. Grease the telescopic profile generously before reassembling.
Caution in Operation