7
805-0039C Rev F
FLOW CONTROL MANIFOLD COVER INSTALLATION
A.
Loosen thumb screws, located on the sides, DO NOT COMPLETELY REMOVE
THUMBSCREWS. Lift the cover off the manifold.
B.
To install cover, align the slots on the cover with the thumb screws on the valve
manifold assembly.
C.
Tighten thumbscrews on each side of cover. DO NOT OVERTIGHTEN.
CAPTIVE O-RING DESIGN (COR)
Below are instructions for the latest revision of the Taprite bar dispenser handle.
The Stem O-rings are located on top of the handle, under the button plate.
The revision includes.
1.
Retainers
266-0329 Retainer, O-Ring 5BRC,7BRC,8BRC,10Button
266-0260 Retainer, O-Ring 12Button
266-0361 Retainer, O-Ring 14Button
2.
Stem, plunger
265-0865 Stem, Plunger Valve BG Captive
BUTTON AND BUTTERFLY PLATE REMOVAL/RE-ASSEMBLY
The Taprite Bar Dispenser handle can be configured into numerous combinations of
carbonated and non-carbonated products. All combinations can be made without
shutting down the system.
Begin by removing the (2) 6-32
x0.5” button
plate s crews located on top of the handle, do
not discard, see
Fig. 9
below.
A.
To change the butterfly plate(s). Remove the (2) 6-32
x.0375”
screws and (2) butterfly
(black)retainers,
Fig.10
.
B.
Remove butterfly plates from handle
Fig. 11
, save screws and butterfly retainers for re-installing.
C.
Ensure that the o-ring retainer(s),
Fig. 12
, below the butterfly plates, are correctly in place before
replacing butterfly plates as required.
D.
Align the pivot balls, at the bottom of the butterfly plates, with the divots in the o-
ring retainer.
E.
Secure butterfly plate(s). Use the (2) 6-
32x.0375”
screws and (2) butterfly
(black)retainers. DO NOT OVERTIGHTEN.
F.
Replace button plate and re-attach with the (2) 6-32x0.5
”
.
INSTALLER TIP:
Verify the O-Rings are seated properly and add lubricant before re-installing
components, see instructions on Removing and Replacing Stem O-Ring.
NOTE:
SEE
“
Non-Captive Stem O-Ring Service
”
IN THE APPENDIX for instructions on removing
and replacing stem o-rings from the bottom of the handle.
Содержание Rattler II
