TAPRITE Rattler II, Инструкция пользователя

Страница: 3 / 33

3 805-0039C Rev F
INSTALLATION
Thank you for purchasing a Taprite 950C bar dispenser. All required mounting
hardware, holster assembly, and ¼” stainless-steel input fittings (with o-rings) are
included with each bar dispenser. The stainless-steel input fittings are installed on the
product side of the bar dispenser manifold ( Fig. 1 ). These fittings are secured in place
using the red retainer clips.
Fig. 1
Attach the base plate (smooth side out) with the provided #8 screws. Please see Page 31
for optimal screw placement.
To install the fitting, press the barb side of the fitting into the tubing and past the last
fittings barb. Secure the tubing to the fitting with an Oetiker® clamp positioned upright.
A. If a staggered setup is necessary, input fittings are available in two additional
lengths:
“medium” (1.5” length), and “long” (2.7” length) ( Fig. 2 ).
IMPORTANT
THIS EQUIPMENT MUST BE CONNECTED TO A POTABLE WATER SUPPLY AND IN-
STALLED WITH ADEQUATE BACK FLOW PREVENTION TO COMPLY WITH FEDERAL,
STATE, AND LOCAL CODES.
IMPORTANT
THE BASEPLATE PROVIDES STABILITY FOR THE BAR DISPENSER AND SHOULD BE AT-
TACHED TO A FLAT SURFACE. FAILURE TO INSTALL THE BAR DISPENSER AND BASE-
PLATE ON A FLAT SURFACE WILL VOID THE WARRANTY AND MAY CAUSE THE VALVE
MODULE ASSEMBLY TO LEAK.
INSTALLER TIP:
Do not install the tubing flush with the flange, this will cause the tubing to interfere with
the retainer clip. Failure to install Oetikers® as shown in Figure 1 will place stress on the
valve module assembly and cause a leak.