TAPRITE Rattler II, Инструкция пользователя

Страница: 6 / 33

6 805-0039C Rev F
Increase
Decrease
Decrease
Adjustment
Screw Metering
screw
Increase
Fig. 6 Fig. 7
D. To achieve the proper water flow rate, adjust the red screw within the flow
control module. For the mechanical application adjust the green metering
screw (
Fig. 7 ).
E. To Ratio/Brix the final product, remove dispensing nozzle on bar gun assembly.
F. Replace the dispensing nozzle with the Taprite syrup separator nozzle. Line up the
separator nozzle on the diffuser and turn to lock the nozzle in place. Ensure there is a
tight seal against the diffuser.
G. Use a ratio cup to measure the syrup to water ratio. Adjust the flow controls to achieve
the target ratio.
Secondary Water
Ratio Screw
Fig. 8
NOTE:
The Bar Dispenser is designed to flow 1.50 oz/sec. finished drink.
This is the proper setting for 5:1 ratio.
INSTALLER TIP:
Depending on the pressure of the incoming plain water, the maximum flow for the dispens-
er may not be achievable. There are two solutions to this problem.
1) Adjust the Brix/Ratio to account for the slower flow rate.
2) Add a water booster to the system.
INSTALLER TIP:
The Taprite Bar Dispenser is equipped with a secondary water ratio screw that is located
on the bottom of the bar dispenser handle near the nozzle ( Fig. 8 ). This may be used to
slow the flow of water to maintain proper ratio for products with ratios 1:1 or 2:1 or any
high-viscosity product. The screw comes from the factory in the open position and should
be used only in the conditions noted. This screw only controls water flow to the products
associated with the bottom right hand butterfly plate.