- 15 -
Pump-over Duration (“Pod”)
This parameter is used to determine how long (in minutes)
the thermostat will wait before resetting the Pump-over state
from “On” to “OFF”.
The unit of measure for this parameter is minutes.
Programming:
1.
Press and release the SET button until the “Pod”
parameter is displayed.
2.
Press the UP or DOWN button once to display the current
parameter value. With the current value displayed, use
the UP/DOWN buttons to adjust the parameter to the
desired value (in minutes).
3.
Hold the SET button to exit programming mode OR press
and release the SET button again to advance to the next
programming parameter
Note: Setting this parameter to zero (0) disables the
automatic pump-over shut off feature and will require cellar
staff to manually turn pump-overs (“Po”) OFF.
This parameter is only accessible while “Po” is set to “On”.
- 16 -
Control Configuration (“CC”)
This parameter is used to grant access to the advanced
thermostat configuration parameters.
Programming:
1.
Press and release the SET button until the “CC” menu
indicator is displayed.
2.
Press the UP or DOWN button to turn this menu “ON”
3.
Press and release the SET button to advance to the first
control configuration parameter.
Note:
This parameter is reset to “OFF” upon exiting programming
mode.
