- 19 -
Cool Probe (“CP”)
The PL-1 thermostat supports two temperature probes. The
Cool Probe (“CP”) parameter tells the thermostat which
probe to use for cooling. Only those probes which are
attached to the thermostat can be assigned to the Cool
Probe parameter.
Programming:
1.
Press and release the SET button until the “CP”
parameter is displayed.
2.
Press the UP or DOWN button once to display the current
parameter value. With the current value displayed, use
the UP/DOWN buttons to toggle this parameter between
the available probes.
3.
Hold the SET button to exit programming mode OR press
and release the SET button again to advance to the next
programming parameter
This parameter is only accessible while the Thermostat Configuration
menu (“CC”) is set to “On”.
- 20 -
Heat Probe (“HP”)
The PL-1 thermostat supports up to eight temperature
probes. The Heat Probe (“HP”) parameter tells the
thermostat which probe (or sensor in the case of a
Stratiprobe
®
) to use for heating. Only those probes which
are attached to the thermostat can be assigned to the Heat
Probe parameter.
Programming:
1.
Press and release the SET button until the “HP”
parameter is displayed.
2.
Press the UP or DOWN button once to display the current
parameter value. With the current value displayed, use
the UP/DOWN buttons to toggle this parameter between
the available probes.
3.
Hold the SET button to exit programming mode OR press
and release the SET button again to advance to the next
programming parameter
This parameter is only accessible while the Thermostat Configuration
menu (“CC”) is set to “On”.
