72
Unit of Temperature for Display: <Select from: Celsius or Fahrenheit > for RTR-51/52/53
Here you can shift the unit of display between Celsius (ºC) and Fahrenheit (ºF).
* When using Fahrenheit in the RTR-52Pt LCD, the Logger can only show between -199.9 and
999.9
à
F. Note that this has no effect on the actual recorded data, but is just a matter of the
display.
Measuring Mode
(Only RVR-52/52A)
[Stop Recording]
Button
[Get Setting]
Button
[Start Recording]
Button
Measuring Mode: [Select from: Voltage (instantaneous value / average value) / Pulse
(Rising / Falling) / Event (Time) / Other (Moisture)] for RVR-52/52A.
Voltage: Instantaneous
value:
Records the voltage at the instant of measurement.
(Unit of measurement in display: V)
Voltage: Average value: If the recording interval has been set for 15 seconds or lower, the
average that is recorded will be from measurements every one
second. If the recording interval has been set for 20 seconds or
higher, the average that is recorded is from every two seconds. (Unit
of measurement in display: V)
Pulse: Rising:
Records the number of rising pulses during the set recording interval.
(Unit of measurement in display: P) Only RVR-52
Pulse: Falling:
Records the number of falling pulses during the set recording interval.
(Unit of measurement in display: P) Only RVR-52
Event: Time:
Events within an input voltage range of 0
ȡ
30V are measured for
every 1 second and the time and date are recorded if any change,
rising (Lo
ɨ
Hi) or falling (Hi
ɨ
Lo), occurs and lasts for more than 1
second. (Unit of measurement in display: P) Only RVR-52 (There is
no set recording interval)
Other: Moisture:
(Only RVR-52A)
Record Moisture by Percentage.
The unit of measurement on the display will show [%] for Percent.
*When measuring moisture, it is necessary to select either [EC-10 Default Values]
or [EC-20 Default Values] in the [Probe Settings]. To open the [Probe Settings]
window, click on [Settings] in the Menu Bar and then select [Moisture Probe
Settings] from the pull down menu.
*To make changes to the measuring mode settings, it is necessary to use optical
communication.
