D14128.02—NOVEMBER 2008
75
Codec C90
System Integrator Guide
Contents
Introduction
Getting Started
Interfaces
About the API
xConfiguration
xCommand
xStatus
Cameras
Appendices
Contact us
xCommand
xCommand HttpFeedback Deregister
Command used to deregister XML eedback over HTTP(S).
Required parameters with (
r
):
FeedbackSlot: <1..3>
Example:
xCommand HttpFeedback Deregister FeedbackSlot:1
OK
*r FeedbackDeregisterResult (status=OK):
FeedbackSlot: 1
*r/end
xCommand Key Click
Command used to emulate pressing a key on the remote control for a short while. This command needs no
release command.
Required parameters with (
r
):
Key(
r
):
<0/1/2/3/4/5/6/7/8/9/C/Call/Disconnect/Down/F1/F2/F3/F4/F5/Grab/Home/
Layout/Left/Mute/MuteMic/Ok/PhoneBook/Presentation/Right/Selfview/
Square/SrcAux/SrcCamera/SrcDocCam/SrcPc/SrcVcr/Star/Up/VolumeDown/
VolumeUp/ZoomIn/ZoomOut>
Duration: <0..65534>
Example:
To be described.
xCommand Key Press
Command used to emulate pressing a key on the remote control without releasing it. The Key Press
command should be followed by a Key Release command to emulate releasing the key.
Required parameters with (
r
):
Key(
r
):
<0/1/2/3/4/5/6/7/8/9/C/Call/Disconnect/Down/F1/F2/F3/F4/F5/Grab/Home/
Layout/Left/Mute/MuteMic/Ok/PhoneBook/Presentation/Right/Selfview/
Square/SrcAux/SrcCamera/SrcDocCam/SrcPc/SrcVcr/Star/Up/VolumeDown/
VolumeUp/ZoomIn/ZoomOut>
Example:
xCommand Key Click Key:Home
*r KeyClickResult (status=OK):
*r/end
OK
The Key commands
