Tandberg Data SDLT220-320 INTEGRATION, Руководство по эксплуатации продукта

Страница: 129 / 142

APPENDIX B: DLT IV Tape Cartridge
Any command that attempts to write to the medium (Write, Write Filemarks,
Erase) will return Check Condition status. The Sense Key will be set to Data
Protect (7) and the ASC/ASCQ will be set to “Cannot Write Medium -
Incompatible Format” (30/05). No update of the tape will be performed.
N
OTE
: For more details about specific SCSI commands and sense
codes, refer to a separate document
Super DLT SCSI Interface Guide, P/N 432614 rev. 01 or later.
B.5 Unloading a Tape Cartridge
Complete this subsection to unload a tape cartridge; refer to Figure B-6 as needed.
1. Press the Eject button (or issue an appropriate system software command); the
drive completes any active writing of data to the tape. The Drive Status LED
blinks as the tape rewinds.
When the tape is finished rewinding, the drive ejects the cartridge and the
Drive Status LED lights steadily.
2. Remove the cartridge from the drive and return the cartridge to its plastic case
to protect the cartridge from damage.
C
AUTION
: Remove the tape cartridge from the tape drive BEFORE
turning off host power. Failure to remove a tape cartridge
may result in cartridge or tape drive damage.
Do NOT rush removal of the tape cartridge: premature
removal can cause tape leader failure. Wait until the drive
ejects the cartridge and the Drive Status LED lights
steadily before removing the cartridge.