Tandberg Data SDLT220-320 INTEGRATION, Руководство по эксплуатации продукта

Страница: 124 / 142

APPENDIX B: DLT IV Tape Cartridge
Follow these steps to visually inspect a DLT cartridge:
1.
Remove the tape cartridge from its protective plastic case.
2. Look at the tape cartridge to check for any obvious cracks or other physical
damage. Look for broken or missing parts.
3.
Gently shake the tape cartridge. Listen for any rattling or sounds of any loose
pieces inside the cartridge. If you hear anything loose inside, do not use the
cartridge.
Figure B-1.
End View of DLT Cartridge
4. Look at the end of the tape cartridge, holding it as shown in Figure B-1 ; now
look at the bottom of the tape cartridge, holding it as shown in Figure B-2 .
Check the reel lock openings and ensure that the small plastic tabs inside are
partially visible. Like any plastic part, the reel locks can break if the cartridge
is dropped. If the reel lock tabs are not visible do not use the cartridge.
Figure B-2. Bottom View of DLT Cartridge
5.
Also located on the bottom of the tape cartridge is the spring-loaded hub.
Verify that the hub is centered within the circular opening in the tape
cartridge. Gently press the hub and make sure that it springs back into place.
Make sure that it ends up centered within its circular opening.