Tandberg Data REPLACE TAPE DRIVE IN T24 OR T48, Руководство пользователя

Страница: 21 / 28

21
OF
28
3. Installing the tape drive —
a. Locate the serial cable (
C
) that came in your replacement kit and attach it to the
appropriate serial connector inside the library .
StorageLibrary T24 library serial cable connections —
Full height tape drive—see Figure 1
StorageLibrary T48 library serial cable connections —
Full height tape drive—see Figure 5
b. While holding the cables to the side, slide the new tape drive directly into the library,
leaving it a short distance out to access the cables. Use care not to damage the cables.
c. Connect the supplied serial cable (
C
) and the power cable (
D
) to the tape drives .
StorageLibrary T24 Full Height tape drive serial and power cable connections —
Serial —Route the serial cable (
C
) over the tape drive carrier and under the power
cable as shown here; connect as shown in Figure 1 (StorageLibrary T24 FH serial
cable routing).
Power —Route the power cable through the tape drive carriers as shown here;
connect as shown in Figure 3 (StorageLibrary T24 FH power cable routing).
!
Important
Do not mix full height and half height or SCSI and Fibre
Channel tape drives in the library. The StorageLibrary T48 does
not support mixed tape drive configurations.
Tape drive Quantity
Install in this
opening...
Serial
connector
Internal
label
Full height Single tape drive Bottom Bottom Drive 1
Tape drive Quantity
Install in this
opening...
Serial
connector
Internal
label
Full height
Second tape drive Top Second Drive 2
Single tape drive Bottom Bottom Drive 1
Tape drive Quantity
Install in this
opening...
Serial
connector
Internal
label
Full height Single tape drive Bottom Bottom Drive 1