Tandberg Data REPLACE TAPE DRIVE IN T24 OR T48, Руководство пользователя

Страница: 10 / 28

10
OF
28
StorageLibrary T48 library serial cable connections —
Full height tape drive—see Figure 5
Half height tape drive—see Figure 6
b. While holding the cables to the side, slide the new tape drive directly into the library,
leaving it a short distance out to access the cables. Use care not to damage the cables.
c. Connect the supplied serial cable (
C
) and the power cable (
D
) to the tape drives.
StorageLibrary T24 tape drive serial and power cable connections —
Serial —Route the serial cable (
C
) over the tape drive carrier and under the power
cable as shown here; connect as shown in Figure 2 (StorageLibrary T24 HH serial
cable routing).
Power —Route the power cable through the tape drive carriers as shown here;
connect as shown in Figure 4 (StorageLibrary T24 HH power cable routing).
Tape drive Quantity
Install in this
opening...
Serial
connector
Internal
label
Half height
Fourth tape drive Top Top Drive 4
Third tape drive Third Third Drive 3
Second tape drive Second Second Drive 2
Single tape drive Bottom Bottom Drive 1
Full height
Second tape drive Top Second Drive 2
Single tape drive Bottom Bottom Drive 1
Figure 11 StorageLibrary T24—installing additional tape drives: half height connectors
Power cable ( D )
Serial cable ( C )
Tape drive
(route over
carrier and
under the
power cable)
(route under carrier
and over serial cable)
carrier
Press the serial cable ( C ) down into the
carrier to prevent catching it between
the tape drive and the library.