Tandberg Data REPLACE TAPE DRIVE IN T24 OR T48, Руководство пользователя

Страница: 15 / 28

15
OF
28
3. Installing the new tape drive —
a. Locate the serial cable (
C
) that came in your replacement kit and attach it to the
appropriate serial connector inside the library.
StorageLibrary T24 library serial cable connections —
Full height tape drive—see Figure 1
Half height tape drive—see Figure 2
StorageLibrary T48 library serial cable connections —
Full height tape drive—see Figure 5
Half height tape drive—see Figure 6
b. While holding the cables out of the way, slide the new tape drive into the library,
leaving it a short distance out to access the cables. Use care not to damage the cables.
c. Connect the supplied serial cable (
C
) and the power cable (
D
) to the tape drives .
StorageLibrary T24 Full Height tape drive serial and power cable connections —
Serial —Route the serial cable (
C
) over the tape drive carrier and under the power
cable as shown here; connect as shown in Figure 1 (StorageLibrary T24 FH serial
cable routing).
Power —Route the power cable through the tape drive carriers as shown here;
connect as shown in Figure 3 (StorageLibrary T24 FH power cable routing).
Tape drive Quantity
Install in this
opening...
Serial
connector
Internal
label
Full height Single tape drive Bottom Bottom Drive 1
Half height
Second tape drive Top Top Drive 2
Single tape drive Bottom Bottom Drive 1
Tape drive Quantity
Install in this
opening...
Serial
connector
Internal
label
Full height
Second tape drive Top Second Drive 2
Single tape drive Bottom Bottom Drive 1
Half height
Fourth tape drive Top Top Drive 4
Third tape drive Third Third Drive 3
Second tape drive Second Second Drive 2
Single tape drive Bottom Bottom Drive 1
Tape drive Quantity
Install in this
opening...
Serial
connector
Internal
label
Full height Single tape drive Bottom Bottom Drive 1