TX7301 Intelligent Sounder Strobe
Installation & Operation Manual
4050100338
-Rev1.1-0916
TANDA UK
Specifications are subject to change without prior notice
8
Figure 9
Figure 10
1.
Attach the programming cable to 1 and 6 Terminals of sounder. Press
“Power”
to switch-on
the unit.
2.
Switch-on the programmer, then press button
“3”
to enter to
Configuration mode
(Figure 9).
3.
Input the
“1”
for
Single
Address mode or
“2”
for Dual Address mode then press
“Write”
to
change the setting into the desire mode (Figure 10).
Note:
If display
“Success”,
means the entered mode is confirmed. If display
“Fail”,
means
failure to program the mode.
In Dual address mode, the sounder will generate the unique next higher number for the
second address for example: In single address mode the address number is 15, when change
to dual address mode the address numbers will now be 15 and 16.
Warning:
Dual address mode may cause Duplicate address fault on the panel and may
affect the operation of the next device with conflicted address number if not carefully
arrange the loop addressing.
4.
Press
“Exit”
key to go back Main Menu. Press
“Power”
to switch off the programmer.
3.4 Typical and Saving Mode
When Sounder-Strobe is configured to Saving Mode the recommended wiring is loop
powered [Figure 2] within the limit of 20 units per loop and subject to the total calculated
current load in particular loop. If Sounder Strobe is configured to Typical Mode, it requires
external power supply [Figure 3] installer should consider additional power cable.
1.
Attach the programming cable to 1 and 6 Terminals of sounder. Press
“Power”
to switch-on
the unit.
2.
Switch-on the programmer, then press button
“3”
to enter to
Configuration mode
(Figure 11).
3.
Input the
“3”
for
Typical
mode or
“4”
for
Saving
mode then press
“Write”
to change the
setting into the desire mode (Figure 12).
Note:
If display
“Success”,
means the entered mode is confirmed. If display
“Fail”,
means
failure to program the mode.
Warning
: Under saving mode loop powered up to 20 sounder strobe maximum per loop is the
recommended.
1. Read
2. Write T
3. R/W Config
7
4. Set
①
Single
②
Dual
③
Typ
④
Saving
⑤
Strobe
⑥
Sound
Configure Description
①
Single
[Default]
②
Dual