TX7301 Intelligent Sounder Strobe
Installation & Operation Manual
4050100338
-Rev1.1-0916
TANDA UK
Specifications are subject to change without prior notice
11
Figure 15
Figure 16
Figure 17
Figure 18
Figure 19
3.7 Read Configuration
1.
Attach the programming cable to 1 and 6 terminals of sounder strobe. Press
“Power”
to
switch on the unit.
2.
Switch-on the programmer, then press button
“Read”
or
“1”
to enter to
Read
mode (Figure
18). The programmer will display the configuration after few seconds. (Figure 19).
4 General Maintenance
1.
Inform the suitable personnel before conducting the maintenance.
2.
Disable the alarm warning device on the control panel to prevent false alarm.
3.
Do not attempt to repair the circuitry of the alarm warning device, it may affect the
operation to respond to a fire condition and will void the manufacturer’s warranty.
4.
Use a damp cloth to clean the surface.
5.
Notify again proper personnel after conducting the maintenance and make sure to enable
the alarm warning device and confirm if up and running.
6.
Perform the maintenance on semi-annually or depending on the site conditions.
1. Read
2. Write T
3. R/W Config
7
4. Set
Tone: 001
Success
Tone: 001
Fail
1. Read
2. Write T
3. R/W Config
7
4. Set
Address: 123,124
Tone: 008
ID: 123456789012
Read Description
Address
: Unique number
assigned
Note: Single address displays
one address while dual
addresses display two
addresses
Tone
: selected audible tone
ID
: Device serial number