TX7301 Intelligent Sounder Strobe
Installation & Operation Manual
4050100338
-Rev1.1-0916
TANDA UK
Specifications are subject to change without prior notice
5
2 Installation
2.1 Installation Preparation
This alarm warning device must be installed, commissioned and maintained by a qualified or factory
trained service personnel. The installation must be installed in compliance with all local codes having
a jurisdiction in your area or BS 5839 Part 1 and EN54.
2.2 Installation and Wiring
1.
Mount the sounder base on standard one Figure [1&2]. Gang electrical back box. Follow the
arrow mark for the correct position. Do not over-tighten the screws otherwise the base will
twist. Use M4 standard screws.
2.
Connect the wire in terminal as shown in Figure [3&4]. Verify the device number or other
device parameters if desired using handheld programmer then stick on the label before
attaching sounder-strobe. The sticker labels are available on the control panel.
3.
Align the Intelligent Sounder Strobe and tabs and gently pushing the device until it locks into
place.
Figure 1
Figure 2
Terminal Description
Z1 Signal In (+)
Z1 Signal Out (+)
Z2 Signal In (-)
Z2 Signal Out (-)
D1 External PSU In (+) Optional
D1 External PSU Out (+)Optional
D2 External PSU In(-)Optional
D2 External PSU Out (-)Optional