TX7301 Intelligent Sounder Strobe
Installation & Operation Manual
4050100338
-Rev1.1-0916
TANDA UK
Specifications are subject to change without prior notice
7
Figure 6
Figure 7
Figure 8
Figure 5
3.2 Addressing
1.
Connect the programming cable to Z1
and Z2 terminals (Figure 5). Press
“Power”
to switch on the unit.
2.
Switch-on the programmer, then press
button
“Write”
or number
“2”
to enter Write
Address mode (Figure 6).
3.
Input the desire device address value from
1 to 254 and then press
“Write”
to save the
new address (Figure 7).
Note:
If display
“Success”
,
means the
entered address is confirmed. If display
“Fail”
,
means failure to program the
address (Figure 8).
4.
Press
“Exit”
key to go back Main Menu. Press
“Power”
key
to switch-off the programmer.
3.3 Single and Dual Address Mode
Single address is commonly used to program immediate Evacuate tone while the dual
address used for programming Pre-alarm and Evacuate tones respectively in a given period
of time.
In Single Address Mode
When in action (Evacuation stage), the sounders will produce visible signal of 1.4 flashes per
second at 1±20% Hz frequency and simultaneously audible signal according to the pre-
defined tone (Table 1- Tone 14 is the default tone) and will stop if the panel is reset.
In Dual Address Mode
When In action the
1
st
Address sounder
(Pre-alarm Stage), will produce visible signal of 0.7
flashes per second at 1±20% Hz frequency and simultaneously audible signal according to
the pre-defined tone (Table 1- Tone 17 is the default tone). This will run continuously
according to the pre-defined time unless the panel is being reset before.
When the delay time is over the 1
st
address sounder will stop then immediately, the
2nd
address sounder
(Evacuate Stage) will produce visible signal of 1.4 flashes per second at
1±20% Hz frequency with simultaneously audible signal according to the pre-defined tone
(Table 1- Tone 14 is the default tone) and will stop if the panel is reset.
1. Read
2. Write T
3. R/W Config 7
4. Set
Address: 001
Next Address: 002
Success
Address: 003
Fail