Tanco 580-J, Руководство оператора

Страница: 43 / 44

- 43 -
Tanco Autowrap 580-S/J
Operator’s manual
THIS IS VERY IMPORTANT
Make sure you have a good connection on the battery both positive and negative
BALE MOVEMENT ON MACHINES
Ensure enrollers (black cone plastic) are in tight to bale, the bale will reduce in size during wrapping, the
corner will become rounded then the bale will tend to move sideways due to central fugal force, if the
rollers are too far apart the bale will move against one end, causing the belt to move in the opposite
direction, always adjust the belt or end cone rollers, so they keep the bale central on the belt.
On trailed machines adjust bale stop on the lift arm so that the bale is loaded centrally on the belt.
Check that the grip-face are securely fixed to the drive roller.
Check that the belt is the same measurement at each side, if one side is longer than the other then replace
the belt.
IF THE PROBLEM STILL OCCURS REMOVE THE CHAIN COVER,
1. Adjust chain so that the chain is at the correct tension
2. Measure the distance between the bearing housing and the adjuster plate (typically from 13 to19
mm)
3. Adjust the opposite end of the driver roller to archive the same measurement.
4. Now you will find that the driver roller is parallel to the chasse.
5. Set idler roller square to driver roller, set from bearing housing to adjusting stop, it should be about
15mm at the start position.
6. If the drive belt is moving to the chain drive side, you will need to make a deeper well at the
opposite end.
7. To create this deeper well first stand facing the turntable at the end of the machine with the chain at
the bottom right hand corner, this corner at the chain drive is ‘A’ the top of the drive roller at the
other end is ‘B’ the top of the idler at other end is ‘C’ and the bottom of the idler at your left is ‘D’.
8.
Now adjust point ‘C’ inward by 10mm
9.
If the problem still occurs adjust point ‘D’ outwards by 2mm at any one time.
10. When any one adjustment is made you may have to wrap a minimum of 5 new fresh bales full cycle
before making any further adjustments.
If making any more adjustments move only 2mm at one time and wrap 5 bales through full cycle.