Tally T2040, Руководство по обслуживанию

Страница: 33 / 108

Problems with the paper
feed The paper is not fed in.
1. Check that the display shows the correct paperway, if necessary select the
correct paperway (single sheet or fanfold) with the key Paper. See the reference
manual on CD-ROM, section
Paper path quick selection .
2. Make sure that the paper guide is correctly adjusted at the side.
3. When using single sheets, push the paper fully into the paper feed.
When having torn off the fanfold paper and after switching over from fanfold paper
to single sheets, the fanfold paper moves to the park position.
4. Check that the fanfold paper is in the park position when you insert a single
sheet. This means the fanfold paper should not be loaded (pulled in). To check
this, raise the guide of the single sheet feeder.
If necessary, drive the remaining paper manually to the park position with the key
↓
.
Paper jam (fanfold paper) Open the top cover. If a paper jam should occur, then remove the jammed paper by
tearing it off at the tear off edge (the tear off edge is located at the outfeed for the
fanfold paper).
Press the key
↓
to transport the paper backwards (substitutes manual knob). You
may support the paper return feed by cautiously pulling the paper in the correct di-
rection.
Before you replace the fanfold paper, refer to the instructions in the section
Inserting paper of the reference manual on CD-ROM.
You should pay special attention to the following points:
Insert the paper straight.
After inserting the paper, close the tractors.
Adjust the tractors, the paper should be positioned in the tractors straight but
without tension.
Adjust the print head gap to the paper thickness (multiple forms, etc.).
Clean upper friction (see Maintenance ).
Paper jam (single sheets) Open the top cover and remove the paper manually or with the functions LF (line
feed)/FF (form feed) in Offline mode from the printer.
Before you replace the single sheet, refer to the instructions in the section Inserting
paper – single sheets of the reference manual on CD-ROM.
Pay attention to the following points:
Set single sheet feed to the corresponding paper width.
Insert the paper straight as far as possible.
Adjust the print head gap to the paper thickness (multiple forms, etc.).
Paper does not move to
tear off position It is only possible to tear off when fanfold paper is used, refer to the section Moving
paper to the tear position of the reference manual on CD-ROM.
Test functions, troubleshooting and maintenance Troubleshooting
4-13