Tally T2040, Руководство по обслуживанию

Страница: 108 / 108

– Insert the push bar D (item 70) vertically in
such a way that the recess 1 on the push bar
engages with the guide provided in the side
plate 2. For this purpose, the mark for position
1 (see also Maintenance Manual, page 3-3,
upper drawing) must be at about 3 mm to the
left of the mark on the side plate. Take care
not to move or turn the gear shaft rear E.
Then slide the push bar into position 1.
Insert the gear shaft front F in such a way that
the ring with the pins points away from you
and the semidisc towards you. The curve of
the semidisc must point to the right, the
straight side to the left at an angle of 90 to the
side plate. The gear shaft front is not
fastened, either.
– Press the gear shaft front F down and slide
the push bar D into position 6. This will fasten
the gear shaft rear E and the gear shaft front F.
Make sure that the straight sides of the
semidiscs of both shafts point to the same
direction and continue to be at an angle of 90
to the side plate.
– Finally, mount the transverse connection plate
(item 52a) and complete the left side plate.
D
1
2
E
F
D
F
E
©
September 1998 Tally GmbH 379 614a
–
Addendum Assembling the FAW