Tally Dascom DM-310/320 User Guide V1.0
31
2.
Set the attached partition in place if
the roll paper you are using is
69.5mm wide or 57.5mm wide.
Change the paper width by changing
the value set as the width using the
Utility tool. (See page 47)
CAUTION:
When setting the roll
paper, be carefull not to
cut your hand on the edge
of the paper.
3.
Place the roll paper in paper
container and pull the end of the roll
paper directly towards you as shown
in the figure.
Hold the center of the roll paper to
pull it as straight as possible so that
one of the sides of the paper does not
slacken.
CAUTION:
Make sure the
print surface is upwards.
Location set for width of 57.5mm
Location set for width of 69.
Содержание DM-310
