Area of Rescue Command Unit
Installation Guide
Model AOR-24 / Model AOR-32
Product Revision 2.0
Page
9
of
23
Rev. 3/8/2022
Copyright 2014-2022 Talk-A-Phone, LLC
• 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • [email protected] • www.talkaphone.com.
All prices and specifications are subject to change without notice. Talk-A-Phone, Talkaphone, bAlert, Scream Alert, WEBS, and WEBS Contact are registered trademarks of
Talk-A-Phone, LLC. All rights reserved. All other trademarks mentioned in this document or website are the property of their respective owners and does not imply or indicate
any approval, endorsement, sponsorship, or affiliation with such owners unless such approval, endorsement, sponsorship, or affiliation is expressly indicated.
13. Routing Cabling:
Route the AOR-CSE Station cabling and any analog (PSTN/POTS) telephone line(s) through the
conduit knockouts located on the rear, top, or bottom sides of the Command Unit chassis.
Always try to separate power lines from communication lines as much as possible to reduce
undesired effects on the communication lines.
14. Terminating AOR-CSE Station Cabling:
Terminate the lines for each AOR-CSE Station to
Ports 1 through 8
(see below illustration) on
the appropriate bank (controller board).
The tip and ring connections for the AOR-CSE Stations are
NOT
polarity sensitive.
