Area of Rescue Command Unit
Installation Guide
Model AOR-24 / Model AOR-32
Product Revision 2.0
Page
14
of
23
Rev. 3/8/2022
Copyright 2014-2022 Talk-A-Phone, LLC
• 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • [email protected] • www.talkaphone.com.
All prices and specifications are subject to change without notice. Talk-A-Phone, Talkaphone, bAlert, Scream Alert, WEBS, and WEBS Contact are registered trademarks of
Talk-A-Phone, LLC. All rights reserved. All other trademarks mentioned in this document or website are the property of their respective owners and does not imply or indicate
any approval, endorsement, sponsorship, or affiliation with such owners unless such approval, endorsement, sponsorship, or affiliation is expressly indicated.
Programming the Command Unit
1.
To program the Command Unit, each controller board (bank of eight (8)) must be configured
individually.
There are two (2) options for programming each controller board:
•
At the Command Unit through use of the local phone;
•
Remotely by calling the phone number of the connected PSTN/POTS telephone line(s).
In either case, the controller board will answer and output one (1) beep.
2.
When entering programming codes, the controller board will provide the following feedback:
One (1) Beep
Programming code successfully accepted
Silence
Error code
—please re-enter the programming code
If you hear silence, re-enter the programming code again. If you continue to hear silence a
second time, hang up and try again.
3. Remote Mode:
In Remote Mode, the controller board(s) does(do) not require any programming. Move onto
Programming the AOR-CSE Stations
.
4. Local Mode:
1.
AOR-24
–
This command unit has three (3) controller boards
—you will need to repeat this
programming process for the second and third banks/controller boards.
Pick up the local phone handset and press the button corresponding to the bank of phones
(i.e. controller board) to be programmed handset (or remotely call into the connected
PSTN/POTS telephone line). Listen for one (1) beep.
AOR-32
–
This command unit has four (4) controller boards
—you will need to repeat this
programming process for the second, third, and fourth banks/controller boards.
Pick up the local phone handset and press the button corresponding to the bank of phones (i.e.
controller board) to be programmed handset (or remotely call into the connected PSTN/POTS
telephone line). Listen for one (1) beep.
2. Enter the Guard Access Code to enter programming mode:
*31**
3. Program the controller board for Local Mode:
*37*
4. Repeat
Steps (1) through (3)
for the remainder of controller boards.
5. Move onto
Programming the AOR-CSE Stations
.
5. Mixed Mode:
1.
AOR-24
–
This command unit has three (3) controller boards
—you will need to repeat this
programming process for the second and third banks/controller boards.
Pick up the local phone handset and press the button corresponding to the bank of phones
(i.e. controller board) to be programmed handset (or remotely call into the connected
PSTN/POTS telephone line). Listen for one (1) beep.
AOR-32
–
This command unit has four (4) controller boards
—you will need to repeat this
programming process for the second, third, and fourth banks/controller boards.
