TALARIA STING, Руководство пользователя

Страница: 28 / 31

www.aebikes.com.au
|
sales@aebikes.com.au
|
page 024
ITEM
ERROR CODES
(MX VERSION) ERROR CODES
(L1E VERSION)
DESCRIPTION ERROR ANALYSIS SOLUTIONS REMARKS
34 E35 00500
Controller MOS
error.
Controller MOS
welding loose or
MOS is broken.
Replace the controller assy.
35 E36 00600
Tip-over sensor
error.
Tip-over sensor got a
poor contact,
or tip-over sensor
broken. Turn off the bike, and stand
the bike to be upright. Then,
re-start the bike. The error
will be eliminted.
If the solution cannot
solve the error,
please send the bike
to the nearest dealer
to inspect and repair.
36 E37 00700 Throttle error.
1. Throttle
connection loose.
2. The throttle didn't
return back to the
proper position
before start.
3.The throttle is
broken.
1. Check the throtte
conection is loose
or broken.
2. Make sure the throttle
return to the proper position
before the start.
3. If the throttle connection
is no problem, and throttler
return to the proper position,
still have the throttle error.
Then, just replace a new
throttle.
37 E38 00800
Low battery
protection error.
When the battery is
low, the low battery
protection will run
automatically.
Charge the battery.
38 E39 00900
Over voltage
protection error
When the voltage of
the battery is equal
or greater than the
protection value,
the over voltage
protection will run
automatically.
Please use Talaria's stock
charger to charge the
battery.
If the solution cannot
solve the error,
please send the bike
to the nearest dealer
to inspect and repair.
39 E40 00A00
Magnetic encoder
error.
Magnetic encoder got
a poor contact or it's
broken.
1. Check whether the
magnetic encoder got a poor
contact? If yes, repair it.
2. If the magnetic encoder
is well contacted, it means
it's broken. Please replace a
new magnetic encoder.
If the solution cannot
solve the error,
please send the bike
to the nearest dealer
to inspect and repair.
40 E41 00B00
Motor phase wire
failure error.
Motor phase wire
loose or incorrect
connection caused
the error
Turn off the bike, and switch
off the circuit breaker. Then,
check the whether the motor
phase wire terminal got
loose, or broken. And then,
check whether the motor
outlet phase sequence
corresponds to the U / V /
W on the controller. Finally,
check whether the magnetic
encoder output wire
corresponds to the yellow,
green and blue wires on the
harness assy.
If the solution cannot
solve the error,
please send the bike
to the nearest dealer
to inspect and repair.