3.4.24 AGP Master 1 WS Read
This implements a single delay when reading to the AGP Bus. By default, two-wait states are used by the
system, allowing for greater stability.
3.5 Integrated Peripherals
You can control Input and Output functions from this screen.
Figure 3-5 Integrated Peripherals
CMOS Setup Utility - Copyright ( C ) 1984 - 2000 Award Software
Integrated Peripherals
OnChip IDE Channel0
Enabled
Item Help
OnChip IDE Channel1
IDE Prefetch Mode
Enabled
Enabled
Menu Level >
Primary Master PIO
Auto
Primary Slave PIO
Auto
Secondary Master PIO
Auto
Secondary Slave PIO
Auto
Primary Master UDMA
Auto
Primary Slave UDMA
Auto
Secondary Master UDMA
Secondary Slave UDMA
Auto
Auto
Init Display First
IDE HDD Block Mode
PCI Slot
Enabled
Onboard FDD Controller
Onboard Serial Port 1
Onboard Serial Port 2
UART 2 Mode
X IR Function Duplex
X
T
x, Rx inverting enable
Onboard Parallel Port
Parallel Port Mode
X
ECP Mode Use DMA
X Parallel Port EPP Type
Onboard Legacy Audio
Sound Blaster
SB I/O Base Address
SB IRQ Select
SB DMA Select
MPU-401
MPU-401 I/O Address
Game Port (200-207H)
Enabled
3F8 / IRQ4
2F8 / IRQ3
Standard
Half
No, Yes
378 / IRQ7
Normal
3
EPP1.9
Enabled
Disabled
220H
IRQ 5
DMA 1
Disabled
330-333H
Enabled
¯
®
¬
: Move Enter : Select +/-/PU/PD : Value F10 : Save ESC : Exit F1 : General Help
F5 : Previous Value F6 : Fail-Safe Defaults F7 : Optimized Defaults
( Scroll down to see more items , as shown here )
3.5.1 OnChip IDE Channel 0/1
Select "Enabled" to activate each on-board IDE channel separately, Select "Disabled", if you install an
add-on IDE Control card
3.5.2 IDE Prefetch Mode
Enable prefetching for IDE drive interfaces that support its faster drive accesses. If you are getting disk
drive errors, change the setting to omit the drive interface where the errors occur. Depending on the
configuration of your IDE subsystem, this field may not appear, and it does appear when the Internal
PCI/IDE filed, above, is Disabled.
3.5.3 Primary & Secondary Master/Slave PIO
These four PIO fields let you set a PIO mode (0-4
)
for each of four IDE devices. When under "Auto"
mode, the system automatically set the best mode for each device
