Taiden HCS-4100MC/50, Инструкция по установке и эксплуатации

Страница: 33 / 60

25
32. “Touch Key Beep Setting ”
Enable/disable touch key beep for HCS-4338/50 series
congress unit. Please hear the beep through earphone.
a). Press the “ Õ / Ö ” button to select “On” or “Off”;
b). Press the “MENU” button to save and return to the
upper level menu.
33. “Headphone Mute Speaker Setting”
Set the work mode between loudspeaker and
headphone.
a). Press the “ Õ / Ö ” button to select “Yes” or “No”;
ƒ If select “
Yes
”, the loudspeaker was muted when
plugged headphone;
ƒ
If select “
No
”, the loudspeaker and the
headphone can work at the same time, the
headphone sends out the floor channel only and
the headphone sends out the floor channel and
SI channels;
b). Press the “MENU” button to save and return to the
upper level menu.
34. “Floor Mode Setting ”
a). Press the “ Õ / Ö ” button to select floor mode;
ƒ
Normal Mode:
the signal on LineIn1 and
LineIn2 of the CMU are added to the floor signal,
see figure 2.8;
ƒ
Insert Mode:
the signal on LineIn2 of the CMU
is used as floor signal, see figure 2.9.
LineIn2 of the CMU is used to add signal from
external audio device; and you can connect an
external audio mixer between LineIn2 and
LineOut;
ƒ
Sync. Line Out1 Mixer:
Adjust the audio
parameters (Conference Management System -
Setup - Audio Output Setup) of LineOut1 and the
floor signal via Mixer 1 synchronously, see figure
2.10. This mode is used in the conference room
without PA.
In the three modes above, if ambient microphone
(used to pick up ambient sound in the congress
room) is enabled via software (Conference
Management System - Setup - Ambient Mic. Setup)
and this microphone is active, its signal is added to
the floor signal only. When any one microphone is
activated, the ambient microphone will be turned
off automatically.
b). Press the “MENU” button to save and return to the
upper level menu.
35.
“
Lock CU LCD Language Setting
”
a). Press the “ Õ / Ö ” button to select “Yes” or “No”;
ƒ If select “
Yes
”, operation language of congress
unit, interpreter unit and operator unit cannot be
changed;
ƒ If select “
No
”, operation language of congress
unit, interpreter unit and operator unit can be
changed;
b). Press the “MENU” button to save and return to the
upper level menu.
36.
“
Nameplates Setting
”
Select turn on the nameplate which is not assigned
delegate unit or not.
a). Press the “ Õ / Ö ” button to select “Turn Off” or “Turn
On”;
b). Press the “MENU” button to save and return to the
Note:
)
For congress unit with two channel selectors,
the loudspeaker was muted automatically
when plugged two headphones even if select
“
No
”.