TAG MCLAREN AUDIO AV32R, Руководство пользователя

Страница: 80 / 86

84
|
programming the remote
6. Release the key on the original remote and re-press and hold it for approximately a
further three seconds. If the learning process has been successful, the status LED will flash
green twice, then return to yellow. If the LED flashes red you need to restart with step 4
as the code could not correctly be interpreted by the remote.
Repeat steps 4 through 6 to program further keys.
7. Once you have finished teaching the AV32R ‘Dual Processor’ remote all the desired
commands from the original remote, you must store them by simultaneously pressing the
appropriate
REMOTE SELECTION key and the ok key for about four seconds.
Once you have stored the ‘learnt’ functions, test the keys you have taught to make sure that
they are programmed correctly.
If the AV32R ‘Dual Processor’ remote has problems learning from the original remote
(1)
, you
should:
• check that the original remote has fresh batteries
• avoid fluorescent lights and strong sunlight, which may interfere with the learning
process
• increase or decrease the distance between the two remotes (within a range of 2 to
15 cm / 1 to 6in)
m1 m2 m3 m4
light
cd
vcr tv
ld
sat
dvd
tuner
md
aux
dab
--- ---
standby
1. Some remotes operate at non-standard infra-red, UHF or ultrasonic frequencies, and cannot be learnt; this is sometimes also caused by
unusual or complex functions which are not universally recognised. If you continue to experience problems programming the remote,
please consult your retailer for advice
The keys m1 to m4 and standby can act as macro keys. These can
be programmed to store up to 10 commands to send together with
one key press. Any key press function (except
mute
,
VIDEO +
and
VIDEO –
) can be programmed into the macro keys. There are 2
groups of macros, one used if the av , cd , dvd or amp remote
selection keys have been pressed, the other for the sat , tv , vcr or ld
keys; i.e. there are a total of 10 macros available.
Macros can only be programmed with either
av
or
sat
selected!
Macros programmed under av will be recalled, pressing m1 , m2 , ...
m4 or standby , when you use av , cd , dvd , or amp . Macros
programmed under sat will be recalled when using sat , tv , vcr
and
ld
.
When using the macro functions, it can take up to 10 seconds to
transmit a 10-key sequence. You should keep the AV32R ‘Dual
Processor’ remote pointing towards the appropriate unit while the
commands are being transmitted to ensure they are received
correctly.
programming macro features
GRP00989.02-UK AV32R Dual.qxd 10/22/03 4:02 PM Page 84