TAG MCLAREN AUDIO AV32R, Руководство пользователя

Страница: 79 / 86

programming the remote
|
83
The remote comes pre-programmed and ready to use for the
following TAG McLaren Audio products:
• audio-visual processor AV32R ‘Dual Processor’
• our range of home cinema amplifiers
• DVD player DVD32R / DVD32FLR
Other devices which are not pre-programmed to work with the
remote will need to be ‘learnt’. To program the remote for other
devices, you will need the original remote for the unit you wish to
operate.
Some devices (other than those listed above) may partially work
with the remote as it is supplied. To check this, select the desired unit
using one of the
REMOTE SELECTION
keys and try pressing a few of
the keys. If the device responds as expected, you may only need to
edit the set-up for that unit by programming one or two keys, as
explained on the following pages, otherwise you will need to
program the remote for all commands.
cd dvd amp av
R E M O T E S E L E C T I O N
sat
tv vcr ld
pause
play
skip
+
record
skip
eject
---
stop
ok
return
cancel
LFE
LFE
---
+
r
e
w
f
f
d
s
image
analog ------
dig ------ dig +
store
erase
station ------
functions
vcr ld tv sat
R E M O T E S E L E C T I O N
cd dvd amp av
1. The remote will stay in learning mode for 20 seconds, after which it will return to normal operation mode if there have been no
further key presses
2. The macro keys m1 to m4 can be programmed with new commands, but if they are used for the macro feature (see ‘programming
macro features’) the new command will be overridden
cd dvd amp av
R E M O T E S E L E C T I O N
sat tv vcr ld
1. Select the device you wish to program by pressing the
appropriate
REMOTE SELECTION
key on the AV32R ‘Dual
Processor’ remote.
2. Place the AV32R ‘Dual Processor’ remote and the remote of the
unit you want to control on a flat surface. Line up the remotes
head to head, about 5 to 10 cm (2 to 3in) apart.
3. Simultaneously press and hold the REMOTE SELECTION key
selected in step 1 and the ok key for about four seconds. The
learning status LED will turn yellow to indicate that the remote is
now in learning mode
(1) .
4. Press and release the key on the AV32R ‘Dual Processor’ remote
which you want to program
(2)
. The status LED will flash yellow.
5. Press and hold for approximately three seconds the key on the
original remote which corresponds to the function you want the
AV32R ‘Dual Processor’ remote to learn. The status LED will
flash shortly in green if the code is correctly understood. If it
flashes red then you need to restart with step 4 as the code was
not understood by the remote.
To ‘learn’ new commands
learning remote
GRP00989.02-UK AV32R Dual.qxd 10/22/03 4:02 PM Page 83