Pro Pump Controller (ProCon-100)
Rev3.6
2023/07/17
6/70
Copyright
©
2023 by TAEHA CORP. All Rights Reserved
Precautions against electric shock
Danger
1.
This equipment is kept under high pressure for a while even after the main
power supply is cut off. When performing a wiring work or inspection that
touches all terminals of the terminal block, leave it for at least five minutes
after shutting off the power before you start the work.
2.
To prevent electric shock and malfunction, please provide class 3 grounding
(100
Ω
or less, wire diameter 1.6mm or thicker).
3.
Inspection and maintenance of this equipment must be performed by a
qualified technician(specialist).
4.
Do not inspect equipment with wet hands, when the floor is wet or if there is
too much moisture. It may cause electric shock.
5.
Be careful not to damage the cable, place heavy objects on it or fold it. In
case it is damaged, it may cause electric shock.
Precautions against fire
Danger
1.
Do not install this equipment near inflammables, combustible organic solvents
or vapors. The heat and electrical operation can cause fire.
2.
If this equipment malfunctions, disconnect the main power supply of the
equipment. The high current may cause a fire.
Precautions of wiring
Danger
1.
Before conducting wiring work for maintenance etc., be sure to shut off all
the external power supplies used by the equipment.
Failure to do so may result in electric shock or damage to the equipment.
2.
To supply power or operate the equipment after wiring, be sure to attach the
covers inside and outside the equipment. Failure to do so may result in injury
and electric shock.
Caution
1.
Do not apply main power supply except for that of the voltage specified in
this user manual. It may cause malfunction.