CD-200-SET
Installation Guide
3
Remark:
in order to install DR-200 panel instead or in addition to the CD-200 refer to
"DR-200-SET: Adapter and panel user guide".
Connect the following wires to the adapter’s terminals. You can assist the attached diagram on page 4.
1,2.
12VAC
– verify the power supply is not connected to the power outlet. Pair of wires from the
power supply can be connected to these terminals or using a plug can be connected to the
socket near these terminals. The polarity is not significant.
Even if you use the socket, you can still draw voltage from the 12VAC terminals.
3.
PANEL1
– pair of wires from the
LINE
terminals of the CD-200 encoder located near the main door.
4.
DOOR1
– control over the main door’s lock. Pair of wires from
REX
terminals of the CD-200 encoder
located near the main door.
5.
PANEL2
- pair of wires from the entrance panel located near the secondary door (if installed).
6.
DOOR2
- control over the secondary door’s lock (if installed) Pair of wires from
REX
terminals of the
CD-200 encoder located near the secondary door.
Telephone line connection:
Attention: the adapter is located between the main telephone line coming to the house and the
telephone lines in the house.
Verify jumper JP4 is not set.
If there is not a communication box, the main telephone line coming to the house should be cut and
connected as described:
7.
PHONE
– pair of wires to the telephones in the house.
8.
LINE
– pair of wires, telephone line coming to the house.
Installing bypass pushbutton
Connect the pushbutton's wires to the CD-200's
REX
terminals, in addition to the wires already
connected from the adapter.
The opening time from pushbutton can be programmed and be different than the keyboard's time.
Installing
the CD-200
According to the door lock type,3 pins Jumper J3 should be set
Desirable RLY state when entering valid code
Jumper J3
Close circuit (Normally open) for electric lock
Jumper on 2 left pins (default state)
Open circuit (Normally close) for magnetic lock
Jumper on 2 right pins
Using Phillips screw driver open the 4 top cover’s screws, carefully pull up the panel.
Using a screw driver, expose the 4 covered insulations bores and the round wires bore.
Attach the base of the panel to the wall.
Using a pencil mark the 4 fixing points and drill them.
Route the wires through the round bore in the base of the panel.
Using 4 screws install the base to the wall.
Connect the wires coming from the adapter as follows:
the polarity of the wires is non significant.
12VAC –
power supply to the CD-200. Pair of wires from the adapter's
12VAC
terminals.
REX –
pair of wires for the first CD-200 from
DOOR1
terminals. Or to the second CD-200
from
DOOR2
.
LINE –
pair of wires for the first CD-200 from
PANEL1
terminals. Or to the second CD-200
from
PANEL2
.
RLY –
electric lock connection. First wire from the lock to one of
RLY
terminals. Second wire
from the lock to one of
12VAC
terminals. A single wire from the second
12VAC
terminal to the second
RLY
terminal.
Reassemble the panel over the base.
Attach the top cover to the base using the 4 screws.
Indication lights in the adapter
Red light – illuminates constantly, indicating there is power supply to the adapter.
Green light:
When turning on the unit – will blink for 2 seconds, indicates correctly initiate.
When calling from one of the panels – flashes in the rhythm of the ringing.
