Tadiran Telecom EMERALD ICE, Руководство по установке

Страница: 91 / 154

Emerald ICE HD Voicemail Installation Manual
9-7
System
Administrator
Ma
ilbo
xes
9
1. From the System Administrator’s Main Menu, dial
3
for Mailbox
Administration.
2. Dial
1
to reset a password. Enter the desired mailbox number.
3. Enter the new password, followed by
#
. The password must be four
digits.
4. After the new password is repeated for verification, press
*
one time to
return to the System Administrator Menu or press
*
two times to exit
the system completely. Give the new temporary password to the
subscriber. Tell them to enter their mailbox immediately to change the
password to one of their own.
Adding a Mailbox
Before a System Administrator adds a mailbox to the system, the class of service,
mailbox type, attendant extension number (or zero destination number) and the
department number all must be already defined. A Emerald ICE HD Voicemail
technician has complete information on setting up a mailbox, including definitions
of all the terms used in this section. Some of the information shown here is not
required to set up a mailbox. The system prompts the System Administrator to
dial
#
when you wish to skip entering certain data.
Follow the steps below to add a mailbox:
1. From the System Administrator’s Main Menu, dial
3
for Mailbox
Administration.
2. Dial
2
to add a mailbox.
3. Enter the mailbox number to be added.
4. Enter the extension number associated with the mailbox.
5. Enter the mailbox class of service (COS).
6. Enter the mailbox type number. These are the numeric equivalents for the
standard mailbox types. Please refer to
Section 5 - Mailbox Programming
for
detailed descriptions of each mailbox type.
7. Enter a zero destination number if desired. Press
1
if the destination
will be an extension that is dialed. Press
2
if the destination will be a
system mailbox. If the zero destination field is left blank, a caller is routed
according to the Site Administration screen entry when
0
is pressed –
this is the default condition.
8. Enter the department number (optional). The information entered in this
field is for reporting purposes only. At this time, the only way to program
the department number is through the keyset.