Tactik TTX600, Инструкция по эксплуатации

Страница: 7 / 24

7
6. The LED on the teacher’s Tx will fl ash 3 times to indicate it has become
bound with the student’s Tx.
7. The teacher can then release his trainer switch.
8. Once both transmitters are bound together, power can be applied to the
receiver to prepare for fl ight.
When the training session has ended, with the model on the ground and all power
removed from the model, place both transmitters within 1 meter of each other and
simply turn the power switch for both transmitters to the OFF position. This will
terminate the wireless link between both transmitters. If additional training will be
performed again, return to step 1 above to re-establish the wireless link between
the teacher and student’s transmitters.
ELEVON & V-TAIL MIXING FUNCTIONS
The TTX600 includes elevon and V-tail mixing functions, which can be turned on or
off. “Elevon” control consists of a mixture between the elevator and aileron channels,
and is useful for certain types of aircraft (such as a fl ying wing). “V-tail” control consists
of a mixture between the elevator and rudder channels and is useful for aircraft which
have a V-tail. The default setting for all mixing will be “off”. To change the mix setting:
1. With the Tx power switch off,
move the right stick to the
bottom-right corner, and the left
stick to the bottom-left corner.
2. While holding the sticks in these
positions, turn the Tx power
switch ON.
3. The LED should fl ash, and if
accompanied by two audible
tones the V-tail mixing function will
now be turned ON. If you do not
wish to again change this setting,
proceed to the next section.
V-Tail Mixing
Left Rudder
ch2 ch4 ch2 ch4 ch2 ch4
Right Rudder Up Elevator