Tactik TTX600, Инструкция по эксплуатации

Страница: 9 / 24

9
environments which might not be recommended. Additional Tactic TR624 receivers
can be purchased from your local retailer (part number TACL0624) to work with this
TTX600 transmitter.
SERVOS
Center the trims on the Tx. Mount the servos inside the model, and connect the
linkages to the servo using an appropriate length servo arm.
All servos should be mounted
as shown in the model’s
instructions. Use rubber
grommets, screws and brass
eyelets supplied (where
applicable) when mounting
your servos (see above).
Do NOT over-tighten the
mounting screws, as the servos should be able to move slightly to compensate for
engine vibration. Use a servo horn long enough to accommodate the entire range
of movement for that particular control. When mounting the servos, make sure
the pushrods are not too loose or bind in any way. Pushrods should be capable
of operating the full range of the servo. This can be tested by moving the Tx sticks
to maximum positions several times while observing the movement of the control
services. If a servo is binding or sticks in fl ight, it should be re-adjusted so as not to
drain excessive current from the battery and thus shorten fl ight time.
Rudder
Servo
(Ch4)
Flap
Servo
(Ch6)
Retract
Servo
(Ch5)
Receiver
Throttle
Servo or
ESC (Ch3)
Elevator
Servo
(Ch2)
Aileron
Servo
(Ch1)
Switch Harness
To Rx Battery
To Charger
6-CHANNEL RECEIVER
Connect the servos to the Rx as shown. Route the wires so they do not interfere
with any moving parts. Move the Tx trims to fi nely adjust the servo’s center point as
needed to match the installation. See the
SERVOS AND ACCESSORIES section on
page 17 for a full list of optional servos.
Rubber Grommet
Brass Eyelet
Servo Servo Servo
Screw
Servo Tray