TACKLIFE DP0813W, Руководство пользователя, Страница: 12 / 22

RAISING OR LOWERING THE TABLE
1.
Loosen the table locking handle (Fig. 8 - 1) so that you can slide the
table to the desired height.
2.
Once the table is at the desired height, securely tighten the table
locking handle.
ROTATING THE TABLE
1.
Loosen the table locking handle (Fig. 8 - 1) so that you can rotate the
table around the column.
2.
Once the table is at the desired position, securely tighten the table
locking handle.
TILTING THE TABLE
1.Loosen the bevel lock bolt (Fig. 9 - 1) with the included M10 hex wrench.
2.Tilt the table to the desired angle, using the table bevel guide (Fig.
10). A level can be used for more precision. Securely re- tighten the
bevel lock bolt.
NOTE: To return the table to its original horizontal position, loosen the
bevel lock bolt and realign the table to the 0° set- ting on the table bevel
guide. A level can be used for moreprecision.
WARNING: To avoid injury, make sure the chuck key is removed
from the chuck before starting any drilling operation.
INSTALLING A DRILL BIT
1.Place the chuck key (Fig. 11 - 1) into the side keyhole
(Fig. 11 - 2) of the chuck, meshing the key with the gear teeth.
2.Turn the chuck key counterclockwise to open the chuck jaws.
3.
Insert a drill bit into the chuck so the chuck jaws grip as much of the
bit’s shank as possible.
4.
Centerthedrillbitinthechuckjawsbeforethefinaltighteningofthechuck.
5.Tighten the chuck jaws using the chuck key to ensure that the drill bit
will not slip while drilling. Tighten the jaws using all three keyholes of
the chuck.
6.Remove the chuck key. Store the key in the rubber key holder,
mounted above the feed handle hub (Fig. 12 - 1).
ADJUSTING THE FEED DEPTH
1.
Loosen the depth locking knobs (Fig. 12, circled).
2.
Turn the depth guide ring (Fig. 12 - 2) to the desired depth.
3.
Lock the depth guide ring in place by tightening the depth locking
knobs.
ADJUSTING THE SPEED
1.To change to another one of the five available speeds, open the belt
housing cover (Fig. 13 - 1) by turning the belt cover knob (Fig 13 - 2)
two rotations counter-clockwise and flipping the belt housing cover up.
2.Loosen the belt tension knob (Fig. 13 - 3).
3.
Use the speed chart (Fig. 15, p. 16) to select a suitable speed for
your specific project. The speed chart can be found on the inner side of
the belt cover (Fig. 19 - 2, p. 17).
4.
Using the belt tension lever (Fig. 14 - 1), pull the motor to- wards the
front of the press and tighten the belt tension locking knob.
Directions continue on the next page.
- 11 -
1
Fig. 9
1
Fig. 8
Fig. 10
1
2
Fig. 11
1
2
Fig. 12
1
2
3
Fig. 13
1
Fig. 14