2
1
WARNINGS.
Read the instructions carefully. It contains important warnings and instructions.
Do not reach into or under the chair when the seat lift and seat tilt is activated, because there is a risk of
entrapment between the mechanical parts.
Be aware of others, especially children, is too close to the chair when the seat lift and seat tilt is activated.
TA Indoor Wave is not intended for users with a weight exceeding 120 kg
TA Indoor Wave should always be turned off when making entry and exit of the chair and when assisted by
a helper, so that the chair does not accidentally run if the joystick is activated.
The chair is EMC tested. However, it is possible that the wheelchair can be affected by electromagnetic
fields from mobile phones for example. Similarly, it cannot be excluded that the chair can emit
electromagnetic fields that can affect the surroundings, such as alarm systems in stores.
Pay particular attention to late run when driving on ramps.
When the chair's brakes are disengaged, the chair may roll if it is on a sloping surface.
Slowing down by pressing the On /Off button there is a risk that the user's torso could fall over.
Ultimately, the user could fall out of the chair.
This kind of slowdown should to the fullest extent be avoided on sloping surfaces and ramps.
By forcing level differences, it is important that the chair runs perpendicular to the obstacle in order to
minimize the risk that the chair should tilt.
By forcing level differences with the seat tilted or hoisted there is a risk that the chair can tip over. By
forcing level differences, it is therefore important that the seat is elevated as little as possible and is as close
to an upright position as possible to minimize this risk.
Driving on steeper slopes should be avoided where possible as this will affect the chairs natural stability, as
the risk of the power chair tipping over is increased. When driving on slopes ensure the following factors are
considered.
The seat should not be lifted, The tilt or backrest recline is not adverse to affect stability,. If in doubt please
contact TA Service or your local dealer, Speed is not excessive, but considered safe in the environment.
When the power chair is used as a seat in a car, bus or similar, the power chair must always be secured with
an approved car attachment. Using 4 point car attachment the hooks must only be attached in the 4
attachment loops on the power chairs. Fastening the hooks elsewhere will cause a high risk of danger to the
user and damage to the power chair. When using a Dahl docking system the instructions from Dahl
Engineering must be followed closely. Failure to follow instructions carefully, will cause a high risk of
danger to the user and damage to the power chair
Avoid touching leaky batteries, as the contents can be harmful.
The temperature of some surfaces can increase and get very hot when in direct sunlight. Especially the
armrest, joystick controller, back/seat and footplate surface, care should be taken to avoid touching with bare
skin.
Repairs and programming of the power chair must be performed by TA Service or a repairer who is
authorized by TA Service.
Unauthorized programming can cause the power chair to handle in a way that could cause danger to the user
or the surroundings.
Only original parts or parts that are approved by TA Service should be used.
