19
EN
IMPORTANT!
If the espresso function is used for the first time, the appliance must be
cleaned as described in the "FIRST USE" paragraph.
IMPORTANT! To prevent splashes of hot water, check that the filter holder
has been tightened until it stops before preparing the coffee. Do not
remove the filter holder while the water is flowing, as the appliance is still
under pressure.
With ground coffee
The type of coffee you choose will determine the strength and taste of your espresso: the
finer your ground coffee, the more intense your espresso will be.
• Fill the water tank with tepid water and refit it on the appliance, making sure that it is
correctly in place.
• Plug in your machine.
• For the best result, we recommend preheating the accessories beforehand (filter holder,
filter and cups) by following the steps above, without adding coffee.
• Turn on the appliance by pressing the On/Off button.
• The "On" indicator light will switch on.
– The selection button
(D.1)
must be set
to the espresso position – (button not
depressed) (D.1.1) (8)
.
– Place a filter without coffee
(F1)
into the filter holder
(F) (9)
. Slot the filter holder into
place
(E)
and turn it to the right until it stops
(10)
. Place a receptacle under the filter
holder
(11)
.
– When the espresso preheating indicator light
(D2.1)
switches on, turn
the thumb
wheel (D.3)
to the left, to espresso preparation
(D.3.2) (12-13)
- The flow will start after
approximately ten seconds.
– Let approximately 300 ml of water trickle out (change the receptacle if necessary)
(14)
,
then turn
the thumb wheel
to position O
(D.3.1)
to stop preparation
(15)
.
2. RINSING THE STEAM SYSTEM
Remove the water tank and fill it. The water level should not exceed the "MAX" mark on
the tank and should contain at least 300 ml (= equivalent to 2 large cups). Then replace the
water tank, ensuring that the cover is closed.
The selection button
(D.1)
must be set
to the steam position (button depressed)
(D.1.2)
(16)
Place the nozzle into a container filled with water
(G.1) (17)
.
When the steam preheating indicator light
(D2.2)
switches on
(18)
, turn the thumb wheel
(D.3)
to the right, to the steam function
(D.3.3) (19)
.
Let the water heat for 20 seconds
(20)
then turn the thumb wheel to position O
(D.3.1)
to
stop the steam
(21)
. Return the selection button
(D.1)
to the espresso position
(D.1.1) (26)
.
MAKING ESPRESSO
