T-Drill S-80, Инструкция по эксплуатации

Страница: 72 / 90

INSTRUCTION MANUAL
72
8.3.1. THE ADJUSTMENT OF THE HEAD
1. Draw a line on the on the adjustment cone and the brake drum to mark the present
setting.
2. Clamp the collaring head by its shank into a bench vice (using however soft jaws,
copper or plastic coated, to avoid damage to the shank).
3. Turn the adjustment cone to completely extend the forming pins. Measure the setting
(see figure below).
I.D.
3
4
1
2
The adjustment of the collaring head: 1. Adjustment cone, 2. Brake drum, 3. Locking
screw, 4. Adjustment tool.
If an adjustment is required, proceed as follows:
1. When the forming pins are completely retracted, loosen both locking screws located in
the cone.
2. Rotate the cone in relation to the brake drum by means of the special adjustment tool.
A: If a larger inner diameter of the collar is required, turn the cone in the (+)
direction.
B. If the inner diameter of the collar is to be smaller, turn the cone in the (-)
direction. The distance between the holes in the brake drum correspond to about
1,1 mm (0,043 inch) in collar inner diameter variation.
3. Tighten one of the locking screws of the cone.
4. Rotate the cone to fully extend the forming pins. Measure once again.
5. If the inner diameter value is alright, tighten both locking screws of the cone carefully.
If the inner diameter adjustment is not satisfactory, repeat the procedure (points 1-4).