T-Drill S-80, Инструкция по эксплуатации

Страница: 23 / 90

COLLARING MACHINE
23
S-80
Current program information
Function
Function number defines what is to be done.
Function number 0-9 are reserved for the special commands.
From that on the first number indicates how many stages the function has, and the
following number indicates what work cycle with this amount of stages is done.
For example:
Function 30 tells that is has 3 stages and the first work cycle is done as described in
the table.
Function 12 tells that it has 1 stage and the first work cycles collaring
Position
Only used when the machine is equipped with an automatic feed table.
With MFT & manual tube support: just for notes.
Rotation Only used when the machine is equipped with a tube rotation module. Expression
0-360 degrees. With MFT & manual tube support: just for notes.
Diameter Diameter of the collar or a round hole. The elliptic pilot hole is defined
automatically by the size of the collar.
Height
The height of the collar from the outer surface of the tube. (The outer surface
is count from the tube outer diameter divided by 2. The diameter value can be
altered by adjusting the offset).
PAUSE
Put the machine to PAUSE by pushing the “STOP” button quickly, the button will start
flashing to inform that the machine is paused. (To switch PAUSE off push “STOP” button
again). The machine is in pause mode, if no one is logged in.
STEP MODE
The step mode is used to run the machine program step-by-step:
Put the machine to PAUSE by pushing the “STOP” button quickly, the button will start
flashing to inform that the machine is paused. (To switch PAUSE off push “STOP” button
again).
Run the program step-by-step by pushing the “START” button, one push is one step.