INSTRUCTION MANUAL
30
6.2 STOPPING THE MACHINE
6.2.1 THE NORMAL STOPPING OF THE F-400 MACHINE
1. Wait until the machine has finished the automatic work cycle
2. Stop the hydraulic motor by pressing the stop push-button .
3. Press the emergency stop push-button (red STOP button) completely down.
4. Disconnect the current to the machine by turning the main switch, on the electric box,
on the back side of the machine, to the position “0”.
5. Close the main valves of the compressed air, of the propane and of the oxygen supply.
6.2.2 THE EMERGENCY STOPPING OF THE F-400 MACHINE
In case of danger, stop the machine by pressing the emergency stop button (the red
STOP-push-button) completely down. This interrupts immediately all functions of the
F-400.
6.3 THE MACHINE SETTING
6.3.1 THE IDENTIFICATION OF THE FORMING PIN
The forming pin which is part of the standard delivery has no particular markings. The
forming pin intended for forming stainless steel bears however the stamped mark “SC” in
the end of the pin.
Forming pins: 1. Standard mild steel pin, 2. ”SC” marked for stainless steel, 3. Expansion
pin. 4. Forming pin for small pipes (Ø33,7 – 42,4)
L
DANGER! When changing the forming pin note to adjust the correct
flanging radius. (See flange standard tables).
Range of use of the F-400 forming pins
F-200 forming pin
Pipe Ø < Ø42,4
F-400 forming pin
Pipe Ø ≥ Ø42,4
