15
Rear Size:
Defines the size and bass capacity of the rear surround
loudspeakers. Select one of the following settings: *)
none
if no surround loudspeakers are present. The
surround channels are mixed down onto the
left and right main loudspeakers.
Note:
Genuine surround reproduction is not possible without
rear speakers!
satellite
for small speakers whose bass reproduction
is necessarily restricted. The low bass content
(below 80 Hz) of the main channel signals is
mixed down onto the subwoofer, if present.
full range
for speakers which offer very good bass
reproduction. The full frequency range is
passed on to the surround channels without
restriction.
*) Note:
To avoid nonsensical settings, the system does not allow
you to set all the possible combinations (
Front LS, Cen-
ter
and
Rear LS
). The following list shows all the stan-
dard combinations, but you can modify them individually
.
Standard combinations
1. Main, center and rear size: .......
Satellite
Subwoofer: ...............................
on
2. Main size: .................................
Full range
Center and rear size: ...............
Satellite
Subwoofer: ...............................
off
3. Main and rear size: ...................
Full range
Center size: ..............................
Full range
or ........................
Satellite
Subwoofer: ...............................
on
Subwoofer:
In this menu point you set whether a subwoofer is pres-
ent in your loudspeaker system. Select one of the fol-
lowing settings:
on
If a subwoofer is present. The signals in the
Low Frequency effect channel (
LFE
), and all
other low-frequency bass signals (below
80 Hz) which are not within the compass of
the full-range loudspeakers, are passed to the
subwoofer channel.
off
If no subwoofer is present. The signals from
the Low Frequency effect channel (
LFE
) and
all other low-frequency bass signals (below 80
Hz) are mixed down onto the main loudspeak-
ers.
Note:
Provided that you have
switched on
the subwoofer in
the
'
Speaker Setup
'
, then you can adjust its level in the
'
Main Menu
'
within the range -10 (dB) to +10 (dB), so
that the volume of the subwoofer matches the volume of
the other channels.
Speaker position:
Activating this menu point leads to a further menu in
which you can define the position of the loudspeakers,
i.e. you can enter the distance from the listening position
to each loudspeaker separately. This enables the de-
coder to compensate for timing discrepancies due to
differences in speaker location (see
'
Speaker Position
Setup
'
).
Noise sequencer:
Activating this menu point leads to a further menu in
which you can set the balance between the volume of all
the loudspeakers (see
'
Speaker Balance Setup
'
).
Tone adjust:
Activating this menu point leads to a further menu in
which you can adjust the tonal balance of the loud-
speakers (see
'
Tone Control Menu
'
).
Содержание DD 1230 R
Страница 1: ...V 2 7 Bestell Nummer 9103 0282 OPERATING INSTRUCTIONS DD 1230 R DD 1530 R ...
Страница 33: ...33 Connecting the digital surround decoder to a TV set and the surround loudspeakers DD 1530 R ...
Страница 35: ...35 Connecting the DD 1530 R to a integrated amplifier with TASI and RLINK sockets ...
Страница 52: ... elektroakustik GmbH Co KG Herford Germany ...
