23
the relative documentation for further information.
INSTALLATION
Before installing the thermostat, make sure that the radio signals transmitted
are correctly received by the receiving unit.
We hereby remind you that the thermostat should be installed away from
sources of heat, drafts and particularly cold or hot walls for the correct
regulation of the room temperature.
Perform the following operations to install the thermostat:
- Remove the knob by using a small screwdriver as a lever in the appropriate
guide, shown by in Fig. 1-2.
- Remove the cap by using a screwdriver on the plastic teeth, shown by in
Fig. 1-2-3, by applying a little pressure between the tooth and the hole in
the plastic, without pressing down directly on it to make sure that it doesn’t
break.
- Correctly insert the batteries respecting the correct polarity. Do not use dead
batteries. Use alkaline batteries and perform the Test function. (See “System
configuration” paragraph.)
- Having identified the best position for installation, fix the bottom of the
thermostat to the walls using two screws, using the two holes with a
distance between the 60mm axes.
Take care not to damage the internal electronic circuits when working with
tools close to the holes of the screws.
- Configure the thermostat; see the “OPERATION” or “SYSTEM
CONFIGURATION” paragraph.
- Close the thermostat by positioning the cap so that the knob’s spindle comes
into contact with the relative hole and then press it slightly until the four
7
10
ENGLISH
PORTUGUÊS
DEUTSCH
ITALIANO
FRANÇAIS
ESPAÑOL
