19
4111-0014 — Apr. 2020
© 2020 Systems, LLC
INSTALLATION
Install Outside Light Assembly and Signs
Note:
Installation measurements shown are
recommended based on typical dock conditions.
Some installations may require alternate placement.
1. Mount the Outside Light Assembly so bottom of
outside light-to-drive distance is 96 in. (2438 mm).
2. Connect the wiring for the Outside Light Assembly.
3. Install “CAUTION: PULL IN OR OUT ON GREEN
ONLY” signs on outside of building above and below
Outside Light Assembly.
4. Install “CAUTION: ENTER ON GREEN ONLY”
sign inside building near control box.
5. Install Placard (see page 20).
The iDock Control System is designed to
function with 12v DC outside lights only.
Using 115v AC or other non-12v DC outside lights
and wiring will cause the iDock Control System to
enter a fault state and equipment will not function.
If 12v DC outside lights are already present and
functioning, they can be re-used, but new wiring
should always be run to ensure correct operation.
Figure 22
TOLERANCES
(UNLESS OTHERWISE NOTED)
FRACTIONAL:
1/32"
DECIMAL:
.00 =
.01"
.000 =
.005"
ANGULAR:
1
DRAWN BY
CHECKED BY
DRAWING NO.
DATE
BDK
4/14/2020
S Y S T E M S
L o a d i n g D o c k E q u i p m e n t
P O W E R A M P
M C G U I R E
D L M
This print is the property of Systems, LLC and represents a proprietary article in which Systems, LLC retains any and all patent and other rights, including exclusive rights
of use and/or manufacture and/or sale. Possession of this print does not convey any permission to reproduce, print or manufacture the article or articles shown therein,
such permission to be granted only by written authorization signed by an officer or other authorized agent of Systems, LLC thereof.
MATERIAL
STOCK NO.
INSTALLATION
OVERVIEW
VIEW 1
REV A - ECN 18-066
96”
(2438
mm)
Approach
Light
Signs
