SYSTEMS McGuire VSH Series, Инструкция для владельца и пользователя

Страница: 24 / 56

22
4111-0024 — Apr. 2020
© 2020 Systems, LLC
Ramp Loading/Unloading
1. Before activating dock leveler, check to make sure
the transport vehicle is positioned squarely against
dock bumpers. Ensure lip will avoid contact with
transport vehicle frame, sides and cargo during dock
leveler activation. If contact is likely or observed,
reposition transport vehicle.
2. Instruct driver to remain at the dock until the
loading or unloading process has been completed.
3. Chock the transport vehicle wheels, or use a
vehicle restraint if available.
4. Extend the dock leveler onto the transport vehicle
as follows:
a. Press and hold the LOWER button until leveler
reaches float zone, then allow leveler to descend
into transport vehicle.
b. Make sure that the lip is fully extended and
supported on the transport vehicle along the entire
width of the platform, with at least 4 in. (102 mm)
of lip contacting the transport vehicle bed.
5. Proceed with loading or unloading the transport
vehicle (see Figure 20).
6. When loading or unloading is finished, raise the
platform by pressing and holding the RAISE button
until the BLUE “Leveler Stored” light turns on.
7. Remove chocks from transport vehicle wheels, or
release the vehicle restraint if used.
8. Indicate to driver that the transport vehicle may
leave the dock.
Operating Instructions
Below Dock End Loading/Unloading
1. Before activating dock leveler, check to make sure
the transport vehicle is positioned squarely against
dock bumpers. Ensure lip will avoid contact with
transport vehicle frame, sides and cargo during dock
leveler activation. If contact is likely or observed,
reposition transport vehicle.
2. Instruct driver to remain at the dock until the
loading or unloading process has been completed.
3. Chock the transport vehicle wheels, or use a
vehicle restraint if available.
4. Press and hold the LOWER button until unit is
about 45 degrees forward, then press the LIP and
LOWER buttons simultaneously and the lip will fold
pendant.
5. Once the lip is pendant, continue to press the
LOWER button until the unit goes into float mode to
the full below dock position.
6. Proceed with loading or unloading (Figure 21).
Note: When end unloading is finished and access to
the rest of the transport vehicle is still required, the
platform lip will need to be extended. Press and hold
RAISE button to clear the transport vehicle bed, then
press the LIP and RAISE buttons simultaneously
to extend the lip. Once lip is extended, follow
instructions for Ramp Loading/Unloading.
7. When loading or unloading is finished, raise the
platform by pressing and holding the RAISE button
until the BLUE “Leveler Stored” light turns on.
8. Remove chocks from transport vehicle wheels, or
release the vehicle restraint if used.
9. Indicate to driver that the transport vehicle may
leave the dock.
OPERATION
Figure 21
Figure 20