SYSTEMS McGuire VSH Series, Инструкция для владельца и пользователя

Страница: 12 / 56

10
4111-0024 — Apr. 2020
© 2020 Systems, LLC
Installation Precautions
Installation of vertical dock levelers from inside
is recommended, as combined height of leveler
and proper lifting equipment may be greater than
outside door height.
File Name: 1751-0138 Rev B
Decal Size: 4 x 2
CRUSH HAZARD
DO NOT REMOVE hydraulic cylinder until leveler is
safely supported by maintenance prop. Refer to
owner’s/user’s manual for proper maintenance
procedure. Failure to comply will result in death or
serious injury.
1751-0138 Rev B
INSTALLATION
DO NOT grind or weld if hydraulic fluid or other
flammable liquid is present on the surface to be
ground or welded.
DO NOT grind or weld if uncontained hydraulic fluid
or other flammable liquid is present. Stray sparks
can ignite spills or leaks near the work area. Always
clean up the oil leaks and spills before proceeding
with grinding or welding.
Always keep a fire extinguisher of the proper type
nearby when grinding or welding.
Only trained installation professionals with the
proper equipment should install this product.
It is recommended and good safety practice to use
an additional means to support the dock platform
and lip anytime when physically working in front of
or under the dock leveler. This additional means
may include, but is not limited to a boom truck, fork
truck, stabilizing bar or equivalent.
Always post safety warnings and barricade the
work area at dock level and ground level to prevent
unauthorized use of the dock leveler before
installation is complete.
A hard hat or other applicable head protection
should always be worn when working under or
around a dock leveler.
Always stand clear of platform lip when working in
front of the dock leveler.
DO NOT connect the dock leveler electrical wiring
and ground connections until all welding has been
completed.
DO NOT ground welding equipment to any hydraulic
or electrical components of the dock leveler. Always
ground welding equipment to the vehicle restraint
base, NEVER to the moving components.
Failure to follow these instructions may damage the
motor, hydraulics, wiring, and/or control panel.
FIG.“A”
File Name: 1751-1293
Decal Size: 3.75 x 6.25
CRUSH HAZARD
DO NOT WORK UNDER OR IN FRONT OF
DOCK LEVELER
unless ALL props have been
properly positioned and secured. First, back out
bolt to position side maintenance prop(s) as shown
in figure “A” below. Then position storage prop and
secure with prop lock pin as shown in figure “B”
below. Failure to do so will result in death or
serious injury. Refer to owner’s/user’s manual for
proper procedure.
Prop Lock
Pin
Storage
Prop
Stored
Position
Maintenance
Position
Bolt
Maintenance
Prop
1751-1293
FIG.“B”