PAGE
12
S
ection 2
•
T
erminating the wiring
Changing the keypad default
setting
Note:
The following section is included to
indicate that some setup may be required
although it will not be possible until the
system is powered up and tested.
The factory default setting for the keypad
is for the local input toggle to be disabled.
If therefore, you plan to use a local input
and wish to select it via the keypad you
will need to enable this feature.
To set the keypad to this mode:
• Make sure that the keypad is operating
normally, put the zone into standby – red
LED ON.
• Depress the
O
and
VOL+
keys on the
keypad simultaneously (both together at
exactly the same time). Hold briefl y until
you see the status LEDs fl ash.
The LEDs will fl ash to show you the new
sequence which is Blue * Green * Blue *
Red (Mode 2 Local enabled).
To revert to the original Mode 1 (local
disabled) repeat the process and the LED
will fl ash Red* Blue * Red * Blue.
2.10 Fitting and connecting
the local input SIM
& IRM modules (if
specifi ed)
If a local input has been specifi ed, and
is located within the zone, it should be
connected as shown:
SIM (rear view)
IRM (rear view)
