SystemAir SYSCOIL MINI 21, Инструкция по установке, эксплуатации и обслуживанию

Страница: 6 / 12

INSTALLATION, OPERATION
AND MAINTENANCE MANUAL
Vers. 2012-0
low profi le
centrifugal fan coil unit
6
RECOMMENDATIONS FOR INSTALLATION
FAN COIL INSTALLATION
Before installing the appliance, ensure that:
1) the place of installation has suffi cient space for carrying out installation as
well as routine and extraordinary maintenance work (see Pic. 4).
2) There are no obstructions for air intake and delivery.
3) The water connections are of the sizes, in the position and spaced apart as
required by the appliance (see Dimension).
4) The system pressure does not exceed 8 bar for the water versions.
5) The electricity supply corresponds to the data on the appliance rating plate
and that there is a afety switch readily accessible to the user to cut off the power
supply whenever necessary.
6) The safety switch is in the OFF position so that there is no voltage on the
appliance supply line.
Before installing the appliance, remove the housing (if present). Raise the fl aps
covering the control panel and the water connections. Remove the two screws
fi xing the housing to the fan coil load-bearing structure. Gipping the rear of the
housing, remove it as shown in the Pic. 5 (NOTE: be careful of the lugs on the
front part of the load-bearing structure, as shown in Pic.10).
Put the cabinet in the packing box to prevent it from being soiled or damaged
(Pic.6)
Offer the appliance up to the required point of installation and mark, through the
fi xing holes, the points on the wall where the holes should be driller for the 4
screw anchors, as shown in Pic. 7.
To replace the housing.
Take the cabinet from the packing box. Standing in front of the fancoil, lift cabi-
net, holding it by the sides, and tilt it (Pic. 10).
Insert the lugs A into the relative slots B (Pic.11). Pivot the cabinet on its base
until it is aligned with the wall. Raise the fl aps covering the control panel and
water connections and tighten the two fi xing screws (Pic.5).
Remove the appliance from the point of installation, drill the holes where mer-
ked on the wall (see Pic. 8) and insert the screw anchors. Place the appliance
against the wall and fi x it by tightening the screws into the anchors see (Pic.
9). Carry out the water and electrical connections as described in the relevant
paragraphs.
Pic. 04
lato attacchi
idraulici
Pic. 10
Pic. 11
Pic. 06
Pic. 07
Pic. 05
Pic. 08 Pic. 09
A
B
>150
>90
>140