background image

5

DXRE

Cleaning

In order to ensure full capacity of the duct cooler, the finned coil 

and droplet eliminator, if fitted, must be regularly cleaned.

The intervals between cleaning are entirely dependent on the 

clean-liness of the air and on how well the filter and the remain-

der of the system are maintained.

CAUTION. Make sure there is no one below the drip tray when 

it is being removed.

Remove the condensate outlet and blank off the connector so that 

any remaining condensate will not run out. Remove the drip tray 

by releasing the excentric lock on the front.

Lower the drip tray about 2–3 cm and then move it towards the 

back so that the locking mechanism at the back will be released. 

The drip tray is held captive by hinges the rear, but it can easily be 

released to enable it to be removed from the DXRE cover.

If a droplet-eliminator is fitted, push the holder to the side and 

remove the droplet eliminator for cleaning with compressed air or

warm water.

Use a soft brush to clean the inlet side of the coil, and the entire 

coil can then be cleaned with compressed air or by vacuum clean-

ing. Blow the dirt away in a direction away from the air outlet side 

and towards the inlet side.

Take care not to deform the edges of the fins.

Clean the bottom of the drip tray, and check that no dirt is lodged 

in the condensate outlet.

Then refit the droplet eliminator with the air direction arrows in 

the correct direction, drip tray and anti condensation insulation.

Modell

B mm H mm S mm R mm I mm

O mm K mm M mm N 

  

mm

Coil inside 

volume, l

Weight, 

kg

DE

DXRE 400x200-3-2,5

438

238

56

70

50

200

165

0

1/2’’

3/8’’

0,8

10,4

DE 40x20

DXRE  500x250-3-2,5

538

288

56

70

40

85

165

67

1/2’’

3/8’’

1,2

13,0

DE 50x25

DXRE  500x300-3-2,5

538

338

56

70

40

85

165

67

5/8’’

3/8’’

1,4

14,6

DE 50x30

DXRE  500x400-3-2,5

538

438

56

70

40

85

165

67

5/8’’

3/8’’

1,9

15,2

DE 50x40

DXRE  600x300-3-2,5

638

338

56

70

40

85

165

67

5/8’’

3/8’’

1,7

16,2

DE 60x30

DXRE 600x350-3-2,5

638

388

56

70

40

85

165

67

5/8’’

3/8’’

1,9

17,4

DE 60x35

DXRE  700x400-3-2,5

738

438

56

70

40

85

165

67

5/8’’

3/8’’

2,5

22,8

DE 70x40

DXRE  800x400-3-2,5

838

438

56

70

40

85

165

67

5/8’’

3/8’’

2,8

25,5

DE 80x50

DXRE  800x500-3-2,5

838

538

86

70

40

85

165

67

7/8’’

3/8’’

3,6

27,8

DE 80x50

DXRE  1000x500-3-2,5

1038

538

86

70

40

85

165

67

7/8’’

1/2’’

4,4

32,0

DE 100x50

DXRE 1200x600-3-2,5

1238

638

86

70

40

95

165

62

7/8’’

1/2’’

6,2

42,0

DE 120x60

 S

 B

9

9

 9

 9

 H

 60

C

N

 330

 395

 I

 O

 K

 M

G½"

Ø10 (8x)

17

R

Содержание DXRE













Отзывы: