D200-101-00
4
I56-3888-105
WIRING INSTALLATION
Power, Alarm and Control Connections
Figure 9: Inside the Detector
CHANNEL 2 FILTER
POWER AND
ALARM
CONNECTIONS
CHANNEL 1 FILTER
USB PORT
SENSOR COVER
POSITION FOR
TEST MAGNET
Exhaust Pipe
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17
18
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17
18
5
6
EARTH BAR
MOUNT
EARTH BAR
MOUNT
F-LT-EB
EARTH BAR
(OPTIONAL)
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17
18
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17
18
3
4
Note 1: All wiring should comply with local
requirements and regulations.
Note 2: Panel wiring must observe the
recommendations of the panel manufacturer
PLACE
WIRING
LABEL
HERE
If the FAAST LT door is closed for a long time
(especially at high temperatures) it may be
necessary to use a flat-bladed screwdriver
between the two tabs at the top of the unit to
lever open the door (as shown above).
SAMPLING AREA
SAMPLING AREA
Whenever the FAAST LT is installed outside the risk area, return of
the exhaust air back into the protected area can reduce flow faults
due to pressure difference.
!
MODULE MOUNT
MODULE MOUNT
F-LT-PMB
MODULE MOUNT
KIT (OPTIONAL)*
*
If required, an input/output module
can be installed into the FAAST LT
unit. The optional module mount kit
(F-LT-PMB) will be needed for this.
